10. Coat the wiper blade with your preferred lubricant. Install
the blade and 2 screws.
11. Re-install the cleaned PCR. Note that a new OEM PCR has
a small amount of conductive grease on the black (contact)
side.
12. Re-Install the OPC Drum and metal axle pin. The metal axle pin should have a small amount of conductive grease on the tip.
Remove the old grease and replace before inserting the pin. Make sure the axle pin is fully inserted.
HP P2035 • 2055 CARTRIDGE REMANUFACTURING INSTRUCTIONS
3232 West El Segundo Blvd., Hawthorne, California 90250 USA • Ph +1 424 675 3300 • Fx +1 424 675 3400 • techsupport@uninetimaging.com • www.uninetimaging.com
© 2009 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only. UniNet Imaging does not warrant downloaded information.
To Next Page
Loading...