Control panel
1. Remove the following components:
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
●
Scanner assembly. See
Scanner assembly on page 13.
2. Open the toner cartridge door and the rear jam access door.
3. On the rear of the control panel, remove the cable cover (callout 1), disconnect one flat, flexible
cable (callout 2), and then pull back the flat, flexible cable.
Figure 1-19 Remove the control panel (1 of 3)
1
2
ENWW
Removal and replacement procedures
15
To Next Page
Loading...
