Right cover
1. Remove the following components:
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
●
Scanner assembly. See
Scanner assembly on page 13.
●
Control panel. See
Control panel on page 15.
2. Open the toner cartridge door and the rear jam access door.
3. Grasp the rear edge of the cover and pull that edge toward the rear to release the four tabs
(callout 1) on the rear edge of the cover, and then use a small flat-blade screwdriver to release the
tab (callout 2) at the top edge of the cover.
Figure 1-22 Remove the right cover
1
2
4. With the back and top edges loose, carefully slide the cover toward the front of the product, and
then remove it.
ENWW
Removal and replacement procedures
17
To Next Page
Loading...
