Rear cover, rear door, and feed assembly
CAUTION: The fuser can be hot while the product is in use. Wait for the fuser to cool before working
in that area.
1. Remove the following components:
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
●
Scanner assembly. See
Scanner assembly on page 13.
●
Control panel. See
Control panel on page 15.
●
Right cover. See
Right cover on page 17.
2. Open the toner cartridge door and the rear jam access door.
3. At the front of the product, in the Tray 2 cassette cavity, pull down on the green duplex-paper-feed-
assembly release tab (callout 1), and then lower the assembly (callout 2).
Figure 1-26 Remove the rear cover, rear door, and feed assembly (1 of 3)
2 1
20 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
