7. Disconnect three connectors (callout 1), remove two screws (callout 2), and then remove the fuser
(callout 3).
Figure 1-42 Remove the fuser (5 of 5)
2
3
1
Duplex drive assembly
1. Remove the following components:
●
Tray 2 cassette
●
Left cover. See
Left cover on page 13.
●
Scanner assembly. See
Scanner assembly on page 13.
●
Control panel. See
Control panel on page 15.
●
Right cover. See
Right cover on page 17.
●
Top cover assembly. See
Top cover on page 18.
2. Open the toner cartridge door and the rear jam access door.
ENWW
Removal and replacement procedures
31
To Next Page
Loading...
