HP LASERJET PRO 400 - Color-Misregistration Sensor Assembly

Color-misregistration sensor assembly
Before proceeding, remove the following components:
●
Print-cartridge drawer. See
Print-cartridge drawer on page 20.
●
Right cover. See
Right cover on page 23.
●
Scanner assembly. See
Scanner assembly on page 26.
●
Simplex products
◦
Rear door. See
Rear door (simplex product) on page 33.
◦
Rear cover. See
Rear cover and feed guide (simplex product) on page 37.
●
Duplex products
◦
Rear-lower cover. See
Rear-lower cover and rear-door links (duplex product) on page 41.
●
Upper-cover assembly. See
Upper-cover assembly on page 51.
●
Left cover. See
Left cover on page 55.
●
High-voltage power-supply PCA. See
High-voltage power-supply PCA on page 87.
Remove the color-misregistration sensor assembly
1. Disconnect one connector (callout 1), and then release the wire harness from the guide (callout 2).
Figure 1-124 Remove the color-misregistration sensor assembly PCA (1 of 4)
1
2
90 Chapter 1 Removal and replacement ENWW