10. Remove the front-door assembly.
Figure 1-85 Remove the front-door assembly (10 of 10)
Reinstall the front-door assembly
Use this procedure if you are installing a
replacement
front-door assembly.
1. Open Tray 1, and then rotate the retainer arm (callout 1) until the tabs on the arm-hinge pin align
with the slots in the mounting hole on Tray 1.
Figure 1-86 Reinstall the front-door assembly (1 of 2)
1
ENWW
Removal and replacement procedures
63
To Next Page
Loading...
