Main assemblies
ITB assembly
CAUTION: ESD sensitive.
Before proceeding, remove the following components:
●
Imaging drum. See
Replace the imaging drum on page 9.
●
Rear top cover assembly. See
Rear top cover assembly on page 22.
●
Rear lower cover assembly. See
Rear lower cover assembly on page 24.
Remove the ITB assembly
1. For wireless products, follow these steps to remove the wireless PCA.
a. Release one tab (callout 1) and disconnect one connector (callout 2) on the back of the
wireless PCA.
Figure 1-24 Remove the ITB assembly (1 of 16)
1
2
b. Remove three screws (callout 1).
NOTE: Base products have only two screws and the appearance of the formatter may be
slightly different from what appears in
Figure 1-24 Remove the ITB assembly (1 of 16)
on page 29.
ENWW
Removal and replacement procedures
29
To Next Page
Loading...
