Table 2-2 Control-panel light patterns (continued)
Light status State of the product Action
Attention light blinks. Ready light is on.
The product is in manual-feed mode. Load the correct paper type and size into
the input tray.
The product is waiting to print the second
side of a manual duplex print job.
Load the input tray with the paper from
the output bin.
Attention light blinks.
The input tray is empty. Load the tray.
Paper is jammed in the product. Clear the jam.
Attention and ready lights are on.
The product has experienced a fatal error
from which it cannot recover.
1. Turn off the product and disconnect
the power cable from the product.
2. Wait 30 seconds and then
reconnect the power cord and turn
on the product.
3. Wait for the product to initialize.
If the error persists, contact HP customer
support.
Attention and ready lights blink.
Paper is jammed in the product. Clear the jam.
Cartridge light blinks.
The print cartridge has rotated and is
now accessible.
Access the print cartridge.
The print cartridge is missing or is not
installed correctly.
Install the print cartridge.
ENWW
Tools for troubleshooting
69
To Next Page
Loading...
