Control-panel module
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1. Remove the right cover. See Right cover on page 10.
2. Open the front door.
3. Disconnect one FFC (callout 1), one wire-harness connector (callout 2), and then remove one
screw (callout 3).
Figure 1-27 Remove the control-panel module (1 of 3)
3
1
2
TIP: The control-panel mounting screw (callout 3) is a self-tapping screw. When reinstalling the
control-panel module, make sure that you replace this screw in the correct position in the
product.
4. Use a small flatblade screwdriver to release one tab (callout 4).
Figure 1-28 Remove the control-panel module (2 of 3)
4
ENWW Removal and replacement procedures 19
To Next Page
Loading...