Power supply (low-voltage)
CAUTION: Do not bend or fold the flat flexible cables (FFCs) during removal or installation. Also, do
not straighten pre-folds in the FFCs. You must make sure that all FFCs are fully seated in their
connectors. Failure to fully seat an FFC into a connector can cause a short circuit in a PCA.
1. Remove the following components:
●
Right cover. See
Right cover on page 10.
●
Left cover. See
Left cover on page 13.
●
Rear-side cover. See
Rear-side cover on page 21.
● Rear door and rear-lower cover. See
Rear door and rear-lower cover on page 23.
2. Remove two screws (callout 1) and the power-supply cover (callout 2).
Figure 1-70 Remove the power supply (low-voltage; 1 of 10)
1
2
ENWW Removal and replacement procedures 47
To Next Page
Loading...