4. Release one tab (callout 4), slide the retainer toward the interface connectors to release it, and
then separate the retainer from the chassis.
Figure 1-82 Remove the power supply (fuser; 3 of 5)
4
5. Remove four screws (callout 5).
NOTE: The two screws near the power switch are ground screws. Make sure that these
screws are placed in the correct positions when the power supply is reinstalled.
Figure 1-83 Remove the power supply (fuser; 4 of 5)
5
5
54 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...