Clean the product
During the printing process, paper, toner, and dust particles can accumulate inside the product. Over
time, this buildup can cause print-quality problems such as toner specks or smearing. This product
has a cleaning mode that can correct and prevent these problems.
1. At the product control panel, press the OK button.
2. Press the right arrow
to highlight the Service menu, and then press the OK button.
3. Press the right arrow
to highlight the Cleaning Page option, and then press the OK button.
Configuration page
The configuration page lists current product settings and properties. This page also contains a status
log report. To print a configuration page, do one of the following:
1. Press OK to open the menus.
2. Press the left arrow
or right arrow button to navigate to Reports, and then press the OK
button.
3. Press the left arrow
or right arrow button to navigate to the report you want to print, and then
press the OK button to print the report.
4. Press Cancel X to exit the menus.
76 Chapter 2 Solve problems ENWW
To Next Page
Loading...