Remove the control-panel assembly
Follow this procedure to separate the control-panel assembly from the front cover.
1. Unthread the control-panel FFC from the guide (callout 1), and loosen the adhesive along the length of
the FFC (callout 2).
Figure 1-31 Remove the control-panel assembly (1 of 4)
1
2
2. Rotate the control panel to the fully open position.
3. Simultaneously push down on the control-panel support arm and push up on the spring assembly. Push
the support arm through the opening.
NOTE: This photo shows a white spring assembly. However, the spring assembly is actually black.
Figure 1-32 Remove the control-panel assembly (2 of 4)
22 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
