Motor PCA and motor
Before proceeding, remove the following components:
●
Paper-delivery tray. See
Paper-delivery tray (output bin extension) on page 12.
●
Left cover. See
Left cover on page 13.
●
Scanner assembly. See
Scanner assembly on page 14.
●
Cartridge door. See
Cartridge door on page 17.
●
Front cover. See
Front cover and control-panel assembly on page 19.
●
Right cover. See
Right cover on page 24.
●
Top cover. See
Top cover and image scanner lock on page 27.
●
Formatter PCA. See
Formatter PCA on page 37.
●
Laser scanner. See
Laser scanner assembly and cable on page 43.
Remove the motor PCA and motor
1. Disconnect the connector at the front of the motor PCA (callout 1). Release two tabs (callout 2), and
slide the motor PCA (callout 3) forward to remove it from the bracket.
Figure 1-71 Remove the motor PCA (1 of 2)
2
1
3
ENWW Removal and replacement procedures 45
To Next Page
Loading...
