IMPORTANT:
Check compatibility and incompatibility between dierent HP Latex printer accessories before any
installation. This information can be found in the user guide, available from:
●
http://www.hp.com/go/latex3000/manuals
●
http://www.hp.com/go/latex3100/manuals
●
http://www.hp.com/go/latex3200/manuals
●
http://www.hp.com/go/latex3500/manuals
●
http://www.hp.com/go/latex3600/manuals
●
http://www.hp.com/go/latex3800/manuals
Printer software
The HP Internal Print Server is provided with your printer and is already installed in the printer’s built-in computer. It
displays printer alerts and a summary of printer status, manages print jobs, and must be used to interact with the
printer in various ways.
The HP Print Care program is provided with your printer and is already installed in the printer’s built-in computer. It
displays printer status and history in detail, and helps you to maintain the printer and solve any problems that may
arise.
A Raster Image Processor (RIP) should be run on a separate computer; it cannot be installed on the printer’s built-in
computer. It is not provided with the printer and should be obtained separately.
Printer messages
Occasionally you may see messages such as the following in the Internal Print Server window. There are two types:
text messages, which are more informative, and messages containing numerical codes, which mean that the printer
has detected a problem or malfunction. When one of these messages appears, please follow any instructions
provided by the printer, and consult the table below. If you feel in doubt about the correct response, or if you have
followed the recommendation but the problem persists, call your service representative.
Message or code Recommendation
[Color] cartridge has expired Replace the cartridge.
[Color] cartridge is altered Replace the cartridge.
[Color] cartridge is low on ink Be ready to replace the cartridge soon.
[Color] cartridge is missing Install the correct cartridge.
[Color] cartridge is non-HP ink You are recommended to install an HP cartridge for best performance.
[Color] cartridge is out of ink Replace the cartridge.
[Color] printhead is missing Install the correct printhead.
[Color] printhead out of warranty The printhead’s warranty has ended, because of the length of time it has
been in operation, because of the volume of ink used, or because non-HP
ink has been used in the system. See the limited warranty document.
An error has occurred in printhead
detection
Remove the printhead, clean any ink from the electrical connectors on the
printhead (do not try to clean the nozzles), and reinsert the printhead.
6 ENWW
English
To Next Page
Loading...
Need help?
General
