EasyManuals Logo

HP Latex 3000 Series Introductory Information

HP Latex 3000 Series
324 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Message or code Recommendation
Checking le system After a dirty power o, the printer performs a le system check, which will
take some minutes.
Checking printer The printer is completing checks and cool-down cycle after nishing a job.
Clean drop detector spittoon Clean the ink deposits.
Cleaner roll jam Go to the Internal Print Server and select the Ink System menu, then Check
cleaner roll. Pull out the printhead cleaning roll assembly, raise the
pinchwheels, wind the roll forward manually, then lower the pinchwheels
and push the assembly back into the printer.
Color calibration canceled because
of scanning errors
The color calibration chart could not be scanned successfully with the
current substrate.
Connecting The Internal Print Server is connecting to the printer.
Connecting printer, please wait The Internal Print Server is starting the printer.
Disconnected The printer is shut down or not detected.
FW upgrade post actions A rmware update is being performed.
Ink drying The printer is drying the last passes of a job after printing it.
Ink system not ready to print Please wait a while. If the printer does not recover, restart it.
Job canceled due to lack of data
received from the IPS
If the problem persists, check the conguration of the built-in computer,
which runs the Internal Print Server.
Line sensor calib. error: substrate
too small
Load a larger substrate.
Low cleaner roll Be ready to replace the printhead cleaning roll soon.
Lower lever Lower the substrate pressure handles.
Maintenance #N advised. Please
contact HP.
You are advised to contact your service representative.
No substrate loaded Load substrate.
Please close safety sensor An open safety circuit has been detected, and should be closed in order to
continue working.
Please press rearm button Press the blue, blinking button to nish the printer’s start-up procedure.
Please release emergency stop An emergency button has been pressed, and must be released to continue
working.
Preparing to print The printer is performing checks and warm-up prior to printing.
ENWW 7
English

Other manuals for HP Latex 3000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Latex 3000 Series and is the answer not in the manual?

HP Latex 3000 Series Specifications

General IconGeneral
BrandHP
ModelLatex 3000 Series
CategoryPrinter
LanguageEnglish

Related product manuals