The following table summarizes the correction type controlled by each pattern.
Pattern Affected printheads Correction type Mode
A Optimizer Substrate axis
B Optimizer Scan axis
C c1, m1 Scan axis
D M1, Y1 Scan axis
E K1, C1 Scan axis
F K1, C1 Substrate axis
G c1, m1 Substrate axis
H M1, Y1 Substrate axis
I C, Y, K, cm, optimizer Scan axis bidirectional (reverse)
J M0, M1 Scan axis bidirectional (reverse)
K C, M, Y, K, cm, optimizer Scan axis bidirectional (reverse) Max dpi
L c0, m0 Scan axis
M M0, Y0 Scan axis
N c0, m0 Substrate axis
O M0, Y0 Substrate axis
Take this into account when trying to compensate for any misalignment observed in the printhead alignment
diagnostics plot.
The central correction is a 10, being the default value for each pattern in the Internal Print Server.
ENWW Align the printheads 99
To Next Page
Loading...
