Turn on the printer for the first time
1. Make sure that the two bottom rows of circuit breakers at the front right of the printer are all in the up
position.
2. Turn the main switch to the on position, and also turn on the PC switch beside it.
3. Check that all three green lights are on. In normal operation these lights should always be on. If any of
them are off, check the Internal Print Server in case there is a system error, and see
Printer messages
on page 265 or check with your electrician.
4. Wait for the Internal Print Server to tell you that the printer is waiting for rearm.
5. Perform a visual check of the printer.
6. Press the blue rearm button at the front right of the printer. This enables all of the printer's high-power
subsystems.
7. Check that the printer-enabled green light turns on. In normal operation this light should always be on.
If at any time you notice that this light is off, check the Internal Print Server in case there is a system
error, and see
Printer messages on page 265.
8. Wait for the Internal Print Server to indicate that the printer is ready. This can take several minutes.
When initialization is complete, the Internal Print Server displays a Ready message. If a system error
message is displayed, see
Printer messages on page 265.
Turn the printer on and off
The printer has three power-off levels. Each of them goes deeper, until you reach complete shutdown at
level 3.
ENWW Turn on the printer for the first time 13
To Next Page
Loading...
