CAUTION: Wrongly positioned edge holders could severely damage the printheads and carriage.
NOTE: If the substrate is loaded with the right edge outside the 161 cm position on the spindle ruler, or the
left edge outside the −162 cm position, the edge holders cannot be used because there is not enough space
for them.
Install an edge holder
To install an edge holder, stand at the front of the printer and attach the front of the edge holder (marked
with the number 1 on the blue part) to the front of the platen. Ensure that the substrate is aligned with the
marks on the edge holder.
ENWW The substrate edge holders 31
To Next Page
Loading...
