Then go to the rear of the printer, open the loading table, pull the rear of the edge holder towards you, and
attach it to the rear of the platen. A built-in magnet helps to position the edge holder correctly on the platen.
Ensure that the substrate is aligned with the marks on the edge holder.
CAUTION: Place the edge holder carefully. It should remain perfectly straight, otherwise it could damage
the printheads and carriage.
TIP: Once installed, an edge holder cannot be slid sideways. If you want to move it sideways, you must
remove it and reinstall it in the new position.
32 Chapter 3 Handle the substrate ENWW
To Next Page
Loading...
