4. Close the tray.
5. The control panel shows the tray’s paper type
and size. If the configuration is not correct, follow
the instructions on the control panel to change
the type or size.
6. For custom-size paper, you need to specify the X
and Y dimensions for the paper when the prompt
displays on the product control panel.
Table 2-2 Tray 2 and Tray 3 paper orientation
Paper type Image orientation Duplex mode How to load paper
Preprinted or letterhead Portrait 1-sided printing Face-down
Top edge at the back of the tray
22 Chapter 2 Paper trays ENWW
To Next Page
Loading...