198 Getting Started (features vary by model)
Adding pictures
To add still-image picture files to the movie project:
1 Click the Add pictures button in the Video/Pictures area. The Add Pictures
window opens.
2 Browse the folders on the hard disk drive to select existing still-image files for
the movie:
 Add up to 50 picture files.
 Select multiple picture files by pressing and holding the Ctrl key on the keyboard
while you select the files.
 Click Open to add pictures to the Video/Pictures area.
3 Adjust the order of the picture files by dragging and dropping them.
4 Click the Rotate Image Clockwise button to rotate a picture.
5 You can use the magicSpot feature in muvee autoProducer to control the pan
and zoom motion that is applied to the picture:
a Click the magicSpot button to open the magicSpot window.
b Click the Manual button to display two overlapping frames over the
picture.
c Move the frames around to set the start and end points for motion. The arrow in
the frames shows the direction of motion.
d When you are done, click OK.
NOTE: To remove a picture from the project, select it, and then click the
trash can icon.
To Next Page
Loading...
Need help?
General