MultiBay II Optical Drive
This section provides information on using optical discs (such as CDs or DVDs) in the MultiBay II.
Inserting an Optical Drive
To insert an optical drive into the MultiBay II, gently slide the drive into the MultiBay II until it is seated,
pressing on the right side of the drive.
Removing an Optical Drive
To remove an optical drive from the MultiBay II:
1. Save your work and close any open applications.
2. Double-click the Safely Remove Hardware icon in the notification area, at the far right of the
taskbar.
3. Click the drive listing, and then click Stop. Click OK again when the “Safe to Remove Hardware”
message is displayed.
4. Gently press the right side of the optical drive (1) to unlock it.
5. Slide the optical drive (2) from the MultiBay II.
ENWW MultiBay II Optical Drive 13
To Next Page
Loading...
