HP officejet 7110 - Page 2

e
d
a b
c
9
1211
10
d
a b
c
TOP
INSTRUCTIONS to Perform 4800 Optimized DPI Alignment
To get the best print quality, you should align your print heads using this page.
Follow these steps:
Step 1. Load the TOP of this page face down on the scanner glass in the front right corner.
Step 2. Press Enter on the front panel when prompted.
Step 3. "4800 optimized align complete" displays on the front panel when you are done.
Please recycle or discard this page.
www.hp.com/support
© Hewlett-Packard Company 2002
a
b
c
a
b
c
hp officejet 7110(xi)/7130(xi) all-in-one
Insert the printheads
Install the software and run the Setup Assistant
Gray print carriage latch
D
o
n
o
t t
ouc
h th
e
t
o
w
e
r
.
Align the printheads
Unwrap and remove the tape
from each printhead.
Do not touch the copper
contacts.
When prompted, press the Enter button on the front panel to begin alignment. Two pages print: an alignment page
and a 4800 dpi alignment page with instructions and test patterns. Printing both pages takes about eight minutes.
When prompted, place the 4800 dpi alignment page face down on the glass, with the top of the page in the front
right corner. Make sure it is straight. Press Enter again.
Discard or recycle the printouts. See the Reference Guide for troubleshooting information, and for information on
printing or copying at 4800 dpi optimized dpi.
a
b
c
Side 2 of 2
Do not touch the co
pp
er contacts
.
Macintosh
setup poster
hp officejet 7110(xi)/7130(xi) all-in-one
Insert the ink cartridges
Unwrap the ink cartridges. Hold each cartridge
away from you as you remove the tape. Do not
touch the copper contacts.
Insert the black ink cartridge into the left side of the
print carriage. Insert the tri-color ink cartridge on
the right side.
Close the door.
a
b
c
Turn on your Macintosh and wait
for it to finish starting up. Insert
the HP Officejet software CD.
Macintosh OS X and OS 9.x
screens may be different.
Double-click the HP All-in-One
installer icon.
Click Install to do an easy
install, then click Continue. If
prompted, restart your
computer.
Hold the ink cartridge away from
clothing. Ink may splash.
Move the print carriage latch
down and make sure the loops
catch the hooks. Snap the latch
into place.
For future reference: do not
remove printheads until you are
ready to replace them.
Lift the door beneath the front
panel until it locks into place.
Remove the plastic carriage
restraint and any other
packaging from inside the unit.
Make sure you complete the Setup
Assistant. Your HP Officejet must be
turned on while you complete software
installation.
If you are using OS X, add the HP
Officejet with the Print Center.
Leave the HP Officejet on for at least
ten more minutes to finish charging.
Printed in USA, Mexico, Germany, and Singapore
Release the gray print carriage
latch.
Then, lift the print carriage to
access the printhead carriage.
Install each of the four printheads.
Match the color and symbol on the
top of the printhead to the color and
symbol on the printhead carriage.
Push down the printhead handles until
the printheads are fully seated.