Load envelopes
Use these instructions to load envelopes.
1. Lift the output tray.
2. Slide the paper guides out as far as possible.
3. Insert the envelopes print-side down and load according to the graphic.
Make sure the stack of envelopes does not exceed the line marking in the tray.
NOTE: Do not load paper envelopes while the printer is printing.
4. Slide the paper guides in the tray to adjust them for the envelope size that you have loaded.
5. Lower the output tray.
6. Pull out the output tray extension.
Load cards and photo paper
Use these instructions to load cards and photo paper.
1. Lift the output tray.
2. Slide the paper guides out as far as possible.
3. Insert the paper print-side down along the right edge of the main tray.
Make sure the stack of paper aligns with the right and back edges of the tray and does not
exceed the line marking in the tray. If the photo paper has a tab along one edge, make sure the
tab is pointing towards the front of the printer.
NOTE: Do not load cards or photo paper while the printer is printing.
4. Slide the paper guides in the tray to adjust them for the paper size that you have loaded.
12 Chapter 1 Get started ENWW
To Next Page
Loading...
