●
Busy redial: If this option is turned on, the printer redials automatically if it receives a busy signal. The
default is On.
●
No answer redial: If this option is turned on, the printer redials automatically if the receiving fax
machine does not answer. The default is Off.
●
Connection problem redial: If this option is turned on, the printer redials automatically if there has
been a problem connecting with the receiving fax machine. Connection problem redial works only for
sending faxes from memory. The default is On.
To set the redial options
1. From the printer control panel display, touch Fax.
2. Touch Setup, and then touch Preferences.
3. Touch Auto Redial.
4. Touch Busy Redial, No Answer Redial, or Connection Problem Redial to switch it on or off.
Set the fax speed
You can set the fax speed used to communicate between your printer and other fax machines when sending
and receiving faxes.
If you use one of the following, setting the fax speed to a slower speed might be required:
●
An Internet phone service
●
A PBX (private branch exchange) system
●
Fax on Voice over Internet Protocol (VoIP)
●
An integrated services digital network (ISDN) service
If you experience problems sending and receiving faxes, try using a slower Fax Speed. The following table
provides the available fax speed settings.
Fax speed setting Fax speed
Fast v.34 (33600 baud)
Medium v.17 (14400 baud)
Slow v.29 (9600 baud)
To set the fax speed
1. From the printer control panel display, touch Fax.
2. Touch Setup, and then touch Preferences.
3. Touch Fax Speed.
4. Touch to select an option.
Set the fax sound volume
You can change the volume of fax sounds.
ENWW Change fax settings 55
To Next Page
Loading...