3. Slide the paper guides in the tray to adjust them for the size that you have loaded.
4. Gently reinsert the tray.
5. Pull out the extension on the output tray.
Configure trays
NOTE: Tray 2 is an optional accessory. For ordering information, see Order printing
supplies online.
To configure the trays, you must have Tray 2 installed and turned on.
By default, the printer draws media from Tray 1. If Tray 1 is empty, the printer draws media
from Tray 2 (if it is installed and loaded with media). You can change this default behavior
by using the following features:
• Tray Lock: Use this feature to protect special media such as letterhead or preprinted
media from accidental use. If the printer runs out of media while printing a document,
it will not use media from a locked tray to complete the print job.
• Default Tray: Use this feature to determine the first tray from which the printer draws
media.
NOTE: To use the tray lock and default tray settings, you must select the automatic
tray selection option in the printer software. Also, if the printer is on a network and
you set a default tray, the setting will affect all users of the printer.
Tray 2 is designed to hold only plain paper.
Install the accessories 23
To Next Page
Loading...