HP OfficeJet Pro 7740 All-in-One series - Test Fax Setup

5
4. Test fax setup
The fax test does the following:
• Tests the fax hardware
• Veries the correct type of phone cord is connected to the printer
• Checks that the phone cord is plugged into the correct port
• Checks for a dial tone
• Checks for an active phone line
• Tests the status of your phone line connection
To run the fax test:
a. On the printer control panel display, touch Fax, touch and slide your nger across the screen, and then
touch Setup.
b. Touch Tools, and then touch Run Fax Test. If the test fails, review the report for information on how to x
the problem, make the suggested changes, and run the test again.
If you still have problems using fax after successfully completing the fax test, visit www.support.hp.com.
How do I set up HP printers in digital phone environments?
HP printers are designed specically for use with traditional analog phone services. If you are in a digital
phone environment (such as DSL/ADSL, PBX, ISDN, or VoIP), you might need to use digital-to-analog lters or
converters when setting up the printer for faxing.
Note: The printer might not be compatible with all digital service lines or providers in all digital environments
or with all digital-to-analog converters. Contact your phone company to determine which setup options are
best for you.
Note: If you are setting up ring pattern detection in a PBX phone system that has dierent ring patterns for
internal and external calls, make sure you dial the fax number of your printer using an external number when
recording the ring pattern.
English