center until they touch the left and right sides of the media, and then gently push
the paper stack to the back of the tray.
NOTE: Do not load paper while the printer is printing.
4. Lower the output tray.
5. Pull out the extension on the output tray.
NOTE: For media longer than 11 inches (279 mm), pull the extension out to
the maximum extended position.
To load Tray 2
1. Pull the tray out of the printer by grasping the front of the tray.
2. Slide the media guides out to the widest setting.
Chapter 1
12 Get started
To Next Page
Loading...
