Multiple pages are being picked up
• Fan the media before loading.
• Make sure the paper guides are set to the correct markings in the tray for the
media size you are loading. Also make sure the guides are snug, but not tight,
against the stack.
• Make sure the tray is not overloaded with paper.
• When using thin special media, make sure that the tray is completely loaded. If you
are using special media that is only available in small quantities, try placing the
special media on top of other paper of the same size to help fill the tray. (Some
media is picked up more easily if the tray is full.)
• If you are using thick special media (such as brochure paper), load media so that
the tray is between 1/4 and 3/4 full. If necessary, place the media on top
of other paper of the same size so that the stack height is within this range.
• Use HP media for optimum performance and efficiency.
Solve printer management problems
This section provides solutions to common problems that involve managing the printer.
This section contains the following topic:
•
Embedded Web server cannot be opened
NOTE: To use the embedded EWS, the printer must be connected to a network
using either an Ethernet connection. You cannot use the embedded Web server if
the printer is connected to a computer with a USB cable.
Embedded Web server cannot be opened
Check your network setup
• Make sure you are not using a phone cord or a crossover cable to connect the
printer to the network.
• Make sure the network cable is securely connected to the printer.
• Make sure the network hub, switch, or router is turned on and working correctly.
Check the computer
Make sure the computer that you are using is connected to the network.
NOTE: To use the EWS, the printer must be connected to a network using either
an Ethernet connection. You cannot use the embedded Web server if the printer is
connected to a computer with a USB cable.
Chapter 4
50 Solve a problem
To Next Page
Loading...
