Main assemblies
Aerosol fan assembly
1. Remove the following components:
●
Rear cover. See
Rear cover on page 23.
●
PCA safety shield. See
PCA safety shield on page 111.
2. Disconnect the control panel flex cable (callout 1). Rotate the ZIF (zero-insertion force)
connector to unclasp the connector first, and then disconnect the cable.
Figure 1-48 Remove the aerosol fan (1 of 12)
1
NOTE: X451 models: The cable should pull straight out.
X551 models: Unclasp the connector first, and then pull the cable.
36 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
