Reinstall the pick assembly/separator
Wear a vinyl glove while handling the new pick assembly to prevent skin oils from contaminating the
roller.
1. Rotate the pick assembly shaft and mounting bracket so that the narrow tabs (callout 1) on the
bracket are positioned near the bottom of the bracket, and the wide tabs (callout 2) are near the
top of the bracket as shown below.
Figure 1-64 Reinstall the separator/pick assembly (1 of 5)
1
2
2. Position the flat side of the pick assembly against the flat side of the pick assembly shaft as
shown below.
Figure 1-65 Reinstall the separator/pick assembly (2 of 5)
46 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
