5. Verify that the tabs are correctly snapped into place and the pick assembly is seated squarely in
the mounting bracket.
Figure 1-68 Reinstall the separator/pick assembly (5 of 5)
6. Reinstall the separator assembly.
Duplex drive module
1. Remove the following components:
●
Rear cover. See
Rear cover on page 23.
●
Aerosol fan assembly. See
Aerosol fan assembly on page 36.
●
Power supply. See
Power supply on page 53.
48 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
