Power supply
CAUTION: Make sure that the power cable is disconnected from the product.
1. Remove the following components:
●
Rear cover. See
Rear cover on page 23.
●
Left door. See
Left door on page 24.
●
Left rear cover. See
Left rear cover on page 27.
●
Aerosol fan assembly. See
Aerosol fan assembly on page 36.
2. Disconnect the cable that connects the power supply to the main PCA.
Figure 1-77 Remove the power supply (1 of 3)
ENWW
Removal and replacement procedures
53
To Next Page
Loading...
