2. Insert the printbar lift lock tool into the printbar lock mount. When mounted correctly and with the
printbar already in the up position, the printbar lift lock tool needs only to be held in place while
the service sled is removed. It locks the printbar in the up position. If you need to raise the
printbar, use a one-quarter inch nut driver to turn the printbar lift lock tool counter-clockwise. Use
extreme caution when driving the printbar lift lock tool to raise the printbar. Over-driving
might break the lock tool.
NOTE: The printbar lift lock tool may look different than what is shown here.
NOTE: Do not use excessive force when installing the printbar lift lock tool.
CAUTION: The printbar lift lock tool must remain in place until either the printbar is removed,
or the service sled assembly is reinstalled in the product. If the printbar drops to the bottom of
the product, the printbar might be damaged, and likely will need to be replaced.
Figure 1-83 Remove the service sled assembly (2 of 6)
58 Chapter 1 Removal and replacement ENWW
To Next Page
Loading...
