8. Coat the new/cleaned wiper blade with your preferred lubri-
cant. Install the wiper blade and 2 screws.
9. Install the cleaned PCR. Place a small amount of conductive
grease on to the black holder side of the shaft. Just a small
amount of grease is more than sufficient.
10. Place another small amount of conductive grease on to
the metal drum axle.
11. Install the new/cleaned drum hub side first. Place the
waste/drum section aside.
UNINET IMAGING INC. • BROTHER 1240/1650 • ASSEMBLING THE TONER CARTRIDGEUNINET IMAGING INC. • BROTHER 1240/1650 • DISASSEMBLING THE TONER CARTRIDGE
UNINET IMAGING INC. • HP P1505 CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2008 UniNet Imaging Inc. All Trademark names are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Summit Technologies is a division of UniNet Imaging Inc.
www.uninetimaging.com
USA • UK • EUROPE • AFRICA • JAPAN • CHINA • BRAZIL • MEXICO • COLOMBIA • ARGENTINA • VENEZUELA
11124 Washington Blvd., Culver City, CA, U.S.A. 90232 • Ph +1 310 280 9620 • Fx +1 310 838 7294 • techsupport2@uninetimaging.com
To Next Page
Loading...