NOTE: If the printer or ink cartridges are moved from a cold location to a warm and humid location, water
from the atmosphere can condense on the printer parts and cartridges and can result in ink leaks and printer
errors. In this case, HP recommends that you wait at least 3 hours before turning on the printer or installing
the ink cartridges, to allow the water to evaporate.
Move or store the high-capacity stacker
Move the high capacity stacker on its own wheels only over smooth, at surfaces and do not attempt to go up
or down steps.
A minimum door or corridor width of 130 cm is required when moving the high-capacity stacker. If the tray
needs to be disassembled to pass through doors or corridors, call your support representative. This should be
done by trained service personnel.
Disconnect the cable before moving or storing the stacker. Reconnect the cable before using the stacker
again.
If you will be using the stacker again with the same printer, its height does not need to change. If you attach it
to a dierent printer, you may need to adjust the height. To adjust the height, turn the screw clockwise (as
shown below) to move the stacker up, or counterclockwise to move it down. Then connect the stacker to the
printer.
NOTE: There is a line in the center of the printer and another in the center of the stacker to help you.
Move or store the folder
Move the folder on its own wheels only over smooth, at surfaces and do not attempt to go up or down steps.
Disconnect the cable before moving or storing the folder.
Before using the folder again, adjust its height and reconnect the cable.
Replace the folder’s tab reel
1. Open the door.
ENWW Move or store the high-capacity stacker 113
To Next Page
Loading...