IMPORTANT: The information provided in the beacon is for functional information purposes only, and is not
relevant to your safety. Warning labels on the printer must be always considered when operating the printer,
regardless of the status indicated by the beacon lights.
White light The printer is ready.
White moving light The printer is printing or preparing to print.
Yellow end light
The printer will need attention soon: for example, it is almost out of ink or
paper. When printing, the yellow light remains at the left, and a white
moving light appears.
Yellow light
The printer can print, but there is something wrong. If the problem
persists, contact your support representative. While printing, you will see
a yellow instead of a white light.
Red light
The printer is unable to print and needs attention, or a major subsystem
of the printer is not working.
You can change the beacon settings by pressing , then System > Beacon. For example, you can change
the brightness of the beacon. You can also turn
o beacon warnings and show only denite errors.
Dim mode
After some time with no activity (5 minutes by default), the printer goes to dim mode, which reduces the
brightness of the front panel by 25% and the brightness of the beacon by 10%. Any activity, such as the use of
10 Chapter 1 Introduction ENWW
To Next Page
Loading...
Need help?
General