◦
The drying module has been damaged (Asia-Pacic and Japan only).
◦
The printer is not operating normally.
●
Turn o the printer in either of the following cases:
◦
During a thunderstorm
◦
During a power failure
●
Take special care with zones marked with warning labels.
Electrical shock hazard
WARNING! The internal circuits of the built-in power supplies and power inlet operate at hazardous voltages
capable of causing death or serious personal injury.
WARNING! The internal circuits of the drying system (Asia-Pacic and Japan only) operate at hazardous
voltages capable of causing death or serious personal injury.
The printer uses one power cord. Unplug the power cord before servicing the printer.
To avoid the risk of electric shock:
●
The printer must be connected to earthed mains outlets only.
●
Do not attempt to dismantle the drying modules (Asia-Pacic and Japan only).
●
Do not remove or open any other closed system covers or plugs.
●
Do not insert objects through slots in the printer.
●
Take care not to trip over the cables when walking behind the printer.
Heat hazard (Asia-Pacic and Japan only)
The printer’s drying subsystem operates at high temperatures and can cause burns if touched. To avoid
personal injury, take the following precautions.
●
Let the printer cool down before accessing the paper output area in case of a paper jam.
●
Let the printer cool down before performing some maintenance operations.
Fire hazard
The internal parts of the printer’s drying subsystem (Asia-Pacic and Japan only) operate at high
temperatures.
To avoid the risk of re, take the following precautions.
●
The customer is responsible for meeting the printer's requirements and the Electrical Code requirements
according to the local jurisdiction of the country where the equipment is installed. Use the power supply
voltage specied on the nameplate.
●
Use only the power cord supplied by HP with the printer. Do not use a damaged power cord. Do not use
the power cord with other products.
●
Do not insert objects through slots in the printer.
●
Take care not to spill liquid on the printer. After cleaning, make sure all components are dry before using
the printer again.
ENWW Safety precautions 3