537489-001 — Removing and Replacing an Add-In Card 5
13 Remove the card:
If there is a release lever, place your finger
between the lever and the card, and then push the
lever out (1) as you lift the card (2) from the
socket.
If there is no release lever, rock the card to free it,
and then lift the card from the socket.
Replacing an Add-In Card
1 Align the edge of the add-in card with the slot in the
computer, and then press the card straight down until
it is fully seated in the socket.
2 Connect any cables to the card.
IMPORTANT: The new (replacement) part may not look
the same as the original part, due to different
manufacturers or models. Hewlett-Packard always
provides quality parts that meet or exceed your original
computer specifications.
To Next Page
Loading...
Need help?
General