17
The camera
is not
recognized
by the
computer
when it is in
the dock
(continued).
There is a
functional
problem with
the dock.
Run the dock functionality test by
unplugging the power cord from
the back of the dock, then holding
down the two buttons on the front
of the dock while you plug the
power cord back into the dock. If
the dock lights come on in
5 seconds (blinking or solid), then
the dock is fully functional.
Images will
not display
on the TV.
The TV accepts
PAL video
format, but the
camera is set to
NTSC video
format.
Change the camera’s TV
Configuration to PAL in the Setup
menu. (See your camera User’s
Manual.)
The TV is not
set to the
correct input
mode.
Check your TV user’s manual to set
the TV to accept video or input
mode.
Audio and
video cables
are switched.
Try switching the audio and video
cables on the back of the TV.
Problem Possible cause Solution
To Next Page
Loading...
