HP Photosmart B109a

Product messages
The following is a list of product-related error messages:
•
Firmware revision mismatch
•
Memory is full
•
Scanner failure
•
Improper shutdown
•
Missing HP Photosmart Software
Firmware revision mismatch
Solution: Contact HP support for service.
Go to:
www.hp.com/support.
If prompted, choose your country/region, and then click Contact HP for information
on calling for technical support.
Cause: The revision number of the product firmware did not match the revision
number of the software.
Memory is full
Solution: Try making fewer copies at a time.
Cause: The document you were copying exceeded the memory of the product.
Scanner failure
Solution: Turn off the product and then turn it on again. Restart your computer and
then try to scan again.
If the problem persists, try plugging the power cord directly into a power outlet rather
than a surge protector or power strip. If the problem continues, contact HP support.
Go to
www.hp.com/support. If prompted, choose your country/region, and then click
Contact HP for information on calling for technical support.
Cause: The product was busy or an unknown cause interrupted your scan.
Improper shutdown
Solution: Press the On button to turn the product on and off.
Cause: The last time the product was used, it was not turned off properly. If the
product is turned off by turning off the switch on a power strip or by using a wall switch,
the product can be damaged.
Missing HP Photosmart Software
Try the following solutions.
•
Solution 1: Install the HP Photosmart Software
•
Solution 2: Check the connection from the product to your computer
Chapter 11
68 Solve a problem
Solve a problem