EasyManua.ls Logo

HP Photosmart C4200

HP Photosmart C4200
155 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
For more information, see:
Communication problems over a USB connection” on page 79
Improper shutdown
Cause: The last time the HP All-in-One was used, it was not turned off properly. If
the HP All-in-One is turned off by turning off the switch on a power strip or by using
a wall switch, the device can be damaged.
Solution: Press the On button located on the control panel of the HP All-in-One to
turn the device on and off.
Two-way communication lost
Cause: The HP All-in-One is turned off.
Solution: Look at the On button located on the top of the HP All-in-One. If it is not
lit, the HP All-in-One is turned off. Make sure the power cord is firmly connected to
the HP All-in-One and plugged into a power outlet. Press the On button to turn on the
HP All-in-One.
Cause: The HP All-in-One is not connected to the computer.
Solution: If the HP All-in-One is not properly connected to the computer,
communication errors can occur. Make sure the USB cable is securely connected to
the HP All-in-One and the computer, as shown below.
For more information, see:
Communication problems over a USB connection” on page 79
Chapter 13
132 Troubleshooting
Troubleshooting

Other manuals for HP Photosmart C4200

Related product manuals