7. To replace the display bezel, remove the two rubber screw covers (1) and the two Torx
T8M2.5×6.0 screws (2) in the bottom corners of the display bezel.
8. Flex the top (3) of the bezel, the inside edges of the left and right sides (4), and then the bottom
(5) of the bezel until it disengages from the display enclosure.
The bezel is available using the following spare part numbers:
646265-001: models without a webcam
646266-001: models with a webcam
9. Remove the display bezel.
92 Chapter 4 Removal and replacement procedures
To Next Page
Loading...
