Removal and replacement procedures
Maintenance and Service Guide 4–9
Mass storage device
✎
The mass storage device spare part kit includes a bracket.
Before removing the mass storage device, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see “Battery” on page 4-7).
Remove the mass storage device:
1. Position the computer with the front toward you.
2. Loosen the two Phillips PM2.5×6.0 captive screws 1 that secure the accessory cover to the computer.
3. Lift the rear edge 2 of the accessory cover to detach it from the computer.
4. Remove the accessory cover 3. The accessory cover is included in the Plastics Kit, spare part number
581100-001.
Description Spare part number
Hard drive:
320-GB, 7200-rpm 581084-001
250-GB, 7200-rpm 581083-001
160-GB, 7200-rpm 581082-001
Solid-state drive:
128-GB 581085-001
80-GB 581086-001
To Next Page
Loading...
