4–28 Maintenance and Service Guide
Removal and replacement procedures
3. Turn the computer display-side up, with the front toward you.
4. Open the computer as far as possible.
5. Release the ZIF connector 1 to which the power button board cable is attached, and then disconnect the power
button board cable from the system board.
6. Release the ZIF connector 2 to which the TouchPad cable is attached, and then disconnect the TouchPad cable
from the system board.
7. Remove the seven slotted Torx T8M2.5×7.0 screws that secure the top cover to the base enclosure.
To Next Page
Loading...
