4–44 Maintenance and Service Guide
Removal and replacement procedures
b. Flex the inside edges of the top edge 1, the left and right sides 2, and the bottom edge 3 of the display
bezel until the bezel disengages from the display enclosure.
c. Remove the display bezel 4. The display bezel is available using spare part number 581092-001.
5. If it is necessary to replace the webcam module:
a. Release the webcam module 1 as far from the display enclosure as the webcam module cable allows.
(The webcam module is attached to the display enclosure with double-sided tape.)
b. Disconnect the webcam module cable 2 from the webcam module.
c. Remove the webcam module. The webcam module is available using spare part number 581106-001.
To Next Page
Loading...
