Removal and replacement procedures
Maintenance and Service Guide 4–47
8. If it is necessary to replace the WWAN antenna transceivers and cables:
a. Detach the WWAN antenna transceivers 1 from the display enclosure. (The transceivers are attached to the
enclosure with double-sided tape.)
b. Release the WWAN antenna cables 2 from the clips and routing channels built into the left and right sides
of the display enclosure.
c. Remove the WWAN wireless antenna transceivers and cables. The wireless antenna transceivers and cables
are included in the Display Cable Kit, spare part number 581093-001.
To Next Page
Loading...
