4–10 Maintenance and Service Guide
Removal and replacement procedures
5. Loosen the Phillips PM2.5×11.0 captive screw 1 that secures the mass storage device in the mass storage
device bay.
6. Remove the two Phillips PM2.5×4.0 screws 2 that secure the mass storage device in the mass storage
device bay.
7. Grasp the Mylar tab 1 on the mass storage device bracket, and slide the mass storage device to the left 2 to
disconnect it from the system board.
8. Remove the mass storage device 3 from the mass storage device bay.
To Next Page
Loading...
